1-866-494-4610

Bell & Gossett 6055B2000 ecocirc Lead Free Brass Solar Circulator 1/2" Sweat

Bell & Gossett 6055B2000 ecocirc Lead Free Brass Solar Circulator 1/2" Sweat
Images for general purposes only. Actual may be different than depicted.
Bell & Gossett 6055B2000 ecocirc Lead Free Brass Solar Circulator 1/2" Sweat

Bell & Gossett 6055B2000 ecocirc Lead Free Brass Solar Circulator 1/2" Sweat

SKU: 6055B2000
Rating:
Quantity Price Stock
Usually Ships 2-3 Weeks
Usually Ships 2-3 Weeks
$380.05     /ea
Usually Ships 2-3 Weeks
0
$0.00
0
$0.00
0
6055B2000

The first DC spherical motor pump for direct connection to photovoltaic panels with automatic performance optimization using Maximum PowerPoint (MPP) tracking.

The ecocirc solar pump can be used for most circulation pump applications without connection to the power grid. Instead the solar pump can be directly connected to the photovoltaic panel. This pump is perfect for single family home thermal solar systems or any circulation pump application where conventional power is not available.

Features and Benefits

  • Runs on DC power for direct connection to photovoltaic panels
  • Low energy consumption: Start-up Power Requires Less than 1 Watt.
  • Lightweight, Easy Installation, Small Footprint
  • Adjustable voltage settings or “Auto” mode for easy use
  • Built in optimization (MPP) program to track and maximize solar input from photovoltaic panel.
  • The only moving part is a hemispherical rotor/impeller unit which sits on an ultra-hard, wear-resistant ceramic ball.
  • There are no conventional shaft bearings or seals eliminating bearing noise and seal leaks.
  • This pump is robust and has an estimated service life in excess of 50,000 hours.
  • The self-realigning bearing is lubricated and cooled by the media.
  • Even after prolonged shutdown, the pump will start reliably.
  • All parts exposed to the fluid are completely corrosion resistant.
Application
  • The ecocirc solar pump can be used for most circulation pump applications without connection to the power grid with direct connection a photovoltaic panel.
  • This pump is perfect for single family home thermal solar systems or any circulation pump application where conventional power is not available.
Design
  • The only moving part is a hemispherical rotor/impeller unit which sits on an ultra-hard, wearresistant ceramic ball.
  • There are no conventional shaft bearings or seals eliminating bearing noise and seal leaks.
  • This pump is robust and has an estimated service life in excess of 50,000 hours.
  • The self-realigning bearing is lubricated and cooled by the media.
  • Even after prolonged shutdown, the pump will start reliably.
  • All parts exposed to the fl uid are completely corrosion resistant.
Soft Start-up
  • When the photovoltaic panel provides suffi cient power, the pump goes through the alignment phase by turning the rotor into the position required for start-up.
  • The processor then waits until the capacitor is suffi ciently charged.
  • This enables a start-up with minimal power (less than one watt).
Over-temperature Safety Device
  • The ecocirc Solar pump comes with an integrated over-temperature safety device which shuts off the pump electronics when reaching temperatures over 230°F.
  • When the temperature of the pumped fl uid is below 203°F the pump will function normally.
  • The temperature of the electronic components is infl uenced by the temperature of the pumped media and by the speed setting.
  • After reaching a critical temperature 203°F the pump will lower its speed automatically in order to avoid a total shutdown.
  • However, if the temperature continues to rise the pump will eventually shut down completely and automatically restart after cooling down.
Motor Design Electronically commutated spherical motor with permanent magnet rotor/impeller
Voltage 12-24V
Acceptable Media Domestic hot water, heating water, water/glycol mixtures
Environment IP 42
Insulation Class Class F

Q & A: Ask the Questions, share answers

Do you have questions about this product?